KPM 2700HP OE-Primary Fuel & PWM System | Trackhawk / Durango

A complete KPM dual-module fuel and PWM package for high-output Trackhawk and Durango SRT Hellcat builds. This OE-primary configuration is engineered for up to 2,700 crank horsepower.

Part Number

KPMTH2700PWM-OE

Vehicle Fitment

• 2018–2021 Jeep Grand Cherokee Trackhawk 6.2L
• 2021 Dodge Durango SRT Hellcat 6.2L

Later Durango model years are not included in KPM’s published fitment for these 2200HP/2700HP systems.

Choose the Correct Configuration

OE-primary system: Retains the factory primary fuel module and adds a KPM 1500HP secondary module. Choose this version when retaining the original primary module.

System Highlights

• Four total high-flow pumps across the primary and secondary modules
• Pre-programmed KPM PWM fuel-module controller
• Six-point Venturi refill strategy helps keep both in-tank canisters supplied
• PWM control stages pump output with fuel demand to reduce unnecessary current draw and heat
• Direct-fit stainless fuel lines and serviceable KPM 2700HP filter
• Compatible with gasoline and ethanol fuels, including E85

What’s Included

• KPM secondary in-tank fuel module
• KPM PWM fuel-module controller
• Fuel-pressure sensor kit
• KPM upgraded fuel lines and KPM 2700HP filter
• Heavy-gauge wiring and connector kit
• Fitting and calibration instructions

Installation & Operating Notes

Professional installation and calibration are required. KPM recommends maintaining sufficient fuel in the tank during drag racing, circuit use or sustained full-load operation. Review the KPM instructions before installation.

Horsepower note: KPM ratings are measured at the crankshaft on gasoline. Actual capacity depends on fuel type, pressure, voltage, engine combination and calibration. Professional installation and tuning are recommended.