Range DFM Pro for GM V8 Trucks and SUVs: Check the Refresh VIN Before Ordering
At SEMA 2026, Range Technology showed DFM Pro, an inline module for selected late-model GM V8 trucks and SUVs. Its appeal is a more consistent engine and pedal-response experience, with several controls collected in a phone app. The buyer's first job, though, is to verify the exact vehicle. GM's midyear truck refresh and the difference between trucks and SUVs make a simple “fits my year” assumption risky.
What the module does
Range lists DFM Pro as manufacturer part RA010. The company says it can disable Dynamic Fuel Management and engine auto start/stop, adjust throttle sensitivity through its smartphone app, and read or clear diagnostic trouble codes. The app also shows emissions-readiness status and can re-enable DFM without removing the module. This is an inline ECM-connected device, not an ECU flash. Those functions are distinct: a different pedal feel does not by itself establish an increase in engine output.
Because the module changes how the vehicle behaves in everyday driving, decide which functions you actually want before ordering. If your aim is only to inspect diagnostic information, compare the available monitoring choices as well. If you want DFM and start/stop behavior changed together, check that RA010 supports your precise application and that you understand how its app controls those settings.
Fitment is more specific than a model-year label
Range's current listing identifies the product for GM “Refresh” V8 applications: 2021–2026 SUVs and 2022.5–2026 GM 1500 trucks with the 5.3L or 6.2L engine. For a 2022 truck, Range says to check the VIN: the 12th digit of a Refresh model must be 5 or higher to confirm compatibility with this unit. That is a particularly important check when shopping for a vehicle made around a midyear change. Verify the exact make, model, engine, VIN and current manufacturer application listing rather than relying on a generic 2022 Silverado or Sierra search result.
Range notes two operating limits worth knowing. A supported vehicle may still enter a zero-cylinder deceleration fuel-cutoff state while coasting at zero throttle. Also, the factory start/stop switch on the dash can continue to illuminate when pressed even though the module's setting controls start/stop behavior. Those details help set expectations during a test drive after installation.
Installation, service and legal use
Range describes RA010 as a plug-in connection at the ECM. It recommends removing the module before GM over-the-air updates or dealer updates through the OBD-II port. Review the current installation instructions and app requirements before purchase, and keep a record of the vehicle's original behavior so you can evaluate the result. The manufacturer's removable design should not be taken as a promise about any particular dealer or warranty decision.
Holley assigns the product emissions code 7 and states that it is not legal for sale or use in California; California Air Resources Board testing is pending. Check the current emissions statement and the rules where the truck or SUV is registered and used. Avoid assuming that an emissions-readiness display itself establishes legal compliance.
The practical purchase checklist is short: identify the vehicle and engine, verify the 2022 Refresh VIN rule if applicable, confirm the desired DFM and start/stop functions, and read the current installation and emissions notes. SMG Speed Shop can help review the right application and related setup before you order.
Manufacturer references: Holley's SEMA 2026 overview and Range DFM Pro RA010 product and application information.